cell phone jammer will adopt outdoor installation

Painting: painting should pay special attention to, believe scrap rate is high, generally two to spray paint, different colors for use behind the laser engraving. Good to spray finished, come back after a procedure. Stamping: is the Do not cut the red flash, leaving the desired key, this procedure can not be rubber edges can not appear; often too small in the corner will have a flash, a not less than 0.5mm. Laser engraving: Laser engraving is, the key is to improve the flat, generally with a positioning system is good, then the key laser carved out of the top layer of paint, tune out the key words to the above, such as numeric keys, is transparent ; if it is carved out only two of the paint layer, leaving a layer, such as ok answer key, and open the key is, a layer of paint is red, there is the blue. The dealer or customer should master how to install   cellular phone jammer at site.Acceptable surface scraping <0.15mm, scraping the bottom acceptable <0.1mm. Poor can not guarantee zero section, try to make the product more than the bottom shell surface shell. In general, the surface shell buttons because there are more holes, forming a large shrinkage, so choose a larger shrinkage, 0.5% in the general election. Bottom molding shrinkage is small, so choose a smaller shrinkage, 0.4% of the general election, that the surface shell shrinkage of 0.1% is generally larger than the bottom shell. Even the choice of two shells of the same material, but also to remind the mold when the mold making factory, whichever is less, after the shell shrinkage.    cell phone jammer      adopts the brand-new imported original devices.
The antenna of    cell phone jammer      coming out of the open on the top
Male mold easily, but low productivity, labor-intensive for small batch production of products; the latter mold complex structure, processing fees when applied to mass production of products, and the desirability of automated production. Qualifying products, including the model results should be the best form of discharge location, location to be considered into the water and sub-surface factors to the size and product shape, depth, proportional to the small pieces of products: 25mm ~ 30mm distance between between the finished product is 15mm ~ 20mm, 25mm, compared with about any inserts, product flow between the at least 15mm. It is the overview of    cell phone jammer     .
The    cellular phone jammer company guarantees to keep the product in good repair for one year.Shielding mechanism: largely thanks to high permeability material with a low reluctance of the flux shunt plays a role, making the magnetic field inside the shield greatly diminished. [Design elements]: a, selection of high-magnetic materials such as permalloy; b, increasing the thickness of the shield; above is the reluctance to reduce the shield; c, the object will not be shielded shielding arrangement in close proximity to body position, to minimize the body through the object to be shielded flux; d, note that the structural design of the shield, where the seams, ventilation and air staff may increase the reluctance shield, thereby reducing the shielding effect. e, can be used for shielding strong magnetic field structure of double-layer magnetic shield. To be shielded from external magnetic field on, then use the outer shield is not easy to saturation of the material, such as silicon; and can be used within easy reach saturation of the high-magnetic materials such as permalloy, etc.