The installation position of phone jammer

There are two options: first, to find a support of DAK or CANON camera memory card storage, open the machine, the machine can Niyitegeka basically, there was no password prompt, because the camera’s system settings like phone has buttons set, the relative cell phone set, it is relatively simple, basically just to support the memory card storage, the more low-end better. The second method [for two version of the machine] is the error that caused Taiwan’s mobile phone solution, QD tried to use this method, the other machine is not clear.  cell phone jammer should be mounted as per the predetermined positions.
Specific programs, the problem is presented using Bluetooth mobile phone equipped with SeleQ, when in loading SeleQ must be stored into the phone, because the choice of memory card, immediately a “system error” into the phone after the restart, and then in the SeleQ you can see the E disk. Then you go to memory card one by one delete file, delete empty until after the return to the SYSTEM folder in C drive will be two MMC prefix file, delete all, go back to the computer card still can not read this When using the method mentioned above can, but need to be patient. (Deleted in the phone it still prompted for a password). Maintenance of   cell phone jammer     should be implemented periodically.
However, no response, even suspended animation, machine card light stays lit, in which case, these two tools are of no use, because they simply open the software can not recognize the memory card. One solution mentioned here: the same is to first find a memory card capacity, into the reader, then right-click “Format” menu to format it, then pull out the card, the menu will not reformat disappear, when you insert that card in question, and then select “FAT32″ format, start format, this process may have to wait a long time, sometimes over a long time, there “Windows” can not complete the format. The shielding range of   phone jammer is limited in this whole building.
The above mentioned provisions of the SD Association, speed rating (SpeedClass), the test methods and general performance testing is quite different. Test based on the card within the fragments were tested for different levels of read and write rate curve rate curve, rather than a single large file transfer speed test. SD Association defines the minimum level required to meet the performance curve, based on test data from the SD Card Association regulations and performance standards for comparison to determine the card’s performance level. The installation position of phone jammer should be easy to be energized.